Smart 7kW BCP Wall Charger – Solar Ready & Secure

This versatile charger works on single-phase power with a solar option. Adjustable output from 6A to 32A, wall or pile mountable, and perfect for Type 2 EVs/PHEVs (Ex-UK/NZ new).

Includes 6mA DC detection, no Type B RCD needed
An Electrician experienced with solar set-ups must install an isolation switch and RCBO 32A 1p slimline (not included)
Features Dynamic Load Balancing (DLB) — set max current via the Z-Box app and the charger smartly adjusts to avoid overloading your home
RFID swipe card for secure, authorized access
Comes with Solar DLB Box to balance solar and grid power
Type 2 to Type 2 lead (6m) permanently attached

Not sure if your EV is Type 2? Call us or check our Charging Guide — just match your port to the Type 2 image below!

DIMENSIONS:

7kg

380mm H x 169mm W x 201/159 mm D

SPECIFICATIONS:

1 phase or 3 phase
Built-in over-voltage and under-voltage protection(U>264V or U<187V).
Over- current protection, over temperature protection, imperfect earth detection.
CP abnormal signal protection and type A + DC 6mA for Europe standard.
Operating temperature range: -25 ℃ ~ +55 ℃.
IP65 (socket IP55) protection rate – provide shelter recommended.
Operating humidity range 0-95% for indoor and outdoor.
Temperature sensor built-in for fire protection.
Leakage test function (to ensure the normal operation of leakage protection).
Automatic reset after troubleshooting. That means when a charger stops working when an anomaly is detected, the charger will periodically self- check whether the anomaly is eliminated. The charger will start to work automatically after ensure the anomaly has been eliminated.
The ramp-down stop current charging mode protects the EV batteries.
Rated charging current can be set according to different home load conditions.
Lightning protection to ensure personal safety.
Standard: EN IEC 61851-1:2019 IEC 61851-1:2017
Certificate: CE/CB/UKCA/SAA
3 year warranty

*** Connecting multiple leads (end to end) together in order to extend the reach is dangerous.

Always ask a qualified electrician to check the wiring of your home before charging any EV/PHEV using your domestic circuits.

Z-Box App for real-time data interface – view charging data, set charging current, voltage and max charging power.

Choose correct DLB mode for solar (optional)
Set weekly charging reservation
Z-Box App for real-time data interface – view charging data, set charging current, voltage and max charging power.
Connect via bluetooth or wifi
Set charging timer
Choose correct DLB mode for solar (optional) – requires purchase of Solar DLB box (extra cost)
Set weekly charging reservation

Three DLB modes for PV (photovoltaic)/Solar mode:

1. The EV charger in the Pure PV (photovoltaic)/Solar mode will control its own charging current as much as possible, so that the actual input value of the grid current is as close as possible to 0A.

2. Hybrid Mode: The EV Charger will control its own charging current as much as possible in the range of DLB setting value. Some will be grid power and some will be solar – depending on the setting you choose.
Example:
Using the Z-Box App on your smartphone edit “Max Grid Current” input value to 10A. If the actual current value from grid to household power is 5A (<=10A), and the PV power generation current is 20A, then the total current of household power is 25A (5A+20A).

3. Full speed mode: The Solar DLB box will no longer limit the charging current of the EV charger, and the wall charger will use the maximum current supported for charging.